[. . . ] We assume no liability whatsoever for failure to follow the proper installation of this products. 1. Do not operate this equipment while driving, driving should always be your highest priority. 2. Do not install components in areas which are susceptible to rain, moisture, direct sunlight, extreme heat or cold, excessive dust, dirt or humidity. [. . . ] 2. Do not install components in areas which are susceptible to rain, moisture, direct sunlight, extreme heat or cold, excessive dust, dirt or humidity. Immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible: a) if there is smoke or any peculiar odor present during use b) if there is damage to any of the internal components 4. To avoid damage to the monitor and risk of electronic shock, do not permit any of this equipment to become damp or wet from water or liquid. If this does occur, immediately unplug the power cord and send the monitor to your local dealer or service center as soon as possible. Dangerous high voltages are present which may result in electric shock. Do not place objects on or suspend objects from the power cord, as this may damage the cord. Do not twist or place the power cord near any source of heat in the vehicle. Avoid dropping any metal objects or inflammable items into the monitor ventilation slots. Take the appropriate precautions to ensure that it is not damaged during the installation. 7 Measurements Push on the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut. Cut the Headrest Using an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner. Repeat the procedure for the other two corners. Remove Foam & Obstructions Carefully peel back the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Remove small section at a time, using the pull up and cut method for uniform depth. Insert the monitor to measure the fit and make adjustments if necessary 8 Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. Before connecting the monitor, pull the connecting cable assembly through the headrest housing as shown in diagram. Place headrest housing into the opening and secure with correct fasteners. [. . . ] Insert the monitor to measure the fit and make adjustments if necessary 8 Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. Before connecting the monitor, pull the connecting cable assembly through the headrest housing as shown in diagram. Place headrest housing into the opening and secure with correct fasteners. [. . . ]